Cisco WS-C2960G-8TC-L Configuration page 23

In this example, three MAC addresses are off of FA0/1, where the first two were
learned dynamically and the last one was statically configured.
12.03. The CD contains a multimedia demonstration of configuring and
ON THE CD CertCam verifying port security on a switch.
2960 Overview
Be familiar with the LEDs on the 2900 series
switches, including the SYSTEM and PORT
LEDs and their colors.
Switch Startup
Understand when the setup script
automatically runs.
Basic Switch Configuration
Be able to put a basic configuration on a
switch: hostname, passwords, assigning an IP
address to a VLAN interface, and assigning a
default gateway address. Know when you must
configure a default gateway address on a switch.
Basic Switch Operation and
Verification
Understand how to view the MAC
addresses in the MAC address table
INSIDE THE EXAM INSIDE THE EXAM
(show mac-address-table) and
how to compare incoming frames to the
table to determine how the switch will
forward the frame.
Port Security Feature
Of the five sections in this chapter, this
section is probably the most emphasized on
the exam. Understand why port security is
used as well as the commands to configure
it. Know why the maximum addresses for
an interface is set to 1. Remember the three
violation modes, as well as what they do. Be
able to compare and contrast dynamic, sticky,
and static learning and when each is used.
And be able to configure this feature on a
switch, since you might see it on a simulation
question!
Port Security Feature
379