Table of Contents
Advertisement
Appendix C
Connecting to DC Power
Figure C-1
0.5 in. (12.7 mm) ± 0.02 in. (0.5 mm)
Slide the open end of the ground lug over the exposed area of the 6-gauge wire.
Step 3
Step 4
Using a Panduit crimping tool, crimp the ground lug to the 6-gauge wire.
Figure C-2
Step 5
Use the two number-10-32 screws to attach the ground lug and wire assembly to the rear panel of the
Catalyst 2950G-24-EI-DC switch or to the front panel of the Catalyst 2950ST-24 LRE 997 switch.
Using a ratcheting torque screwdriver, torque each ground-lug screw to 15 lbf-in. (240 ounce-force
Step 6
inches [ozf-in.]).
switch.
OL-6156-01
Stripping the Ground Wire
Insulation
Crimping the Ground Lug
Figure C-3
shows how to torque the ground screws on a Catalyst 2950G-24-EI-DC
Wire lead
Catalyst 2950 Switch Hardware Installation Guide
Grounding the Switch
C-3
Hide quick links:
Advertisement
Table of Contents
