Port Management > Port Status; Port Status; Firewall > General; General - Cisco RV042 - Small Business Dual WAN VPN Router User Manual

Chapter 4
Priority
For port-based QoS, select the appropriate
priority level, High or Normal.
Speed Select the port speed, 10M or 100M.
Duplex Select the duplex mode, Half or Full.
Auto Neg. Select Enable if you want the Router's ports
to auto-negotiate connection speeds and duplex mode;
then you will not need to set up speed and duplex settings
separately.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
Port Management > Port Status
Status information is displayed for the selected port.
Port Management > Port Status
Port ID
To see the status information and settings for a
specific port, select its ID number or name.

Port Status

Summary
For the selected port, the Summary table displays the
following:
Type
The port type is displayed.
Interface
The interface type, LAN or WAN, is displayed.
Link Status
The status of the connection is displayed.
Port Activity
The status of the port is displayed.
Speed Status
The speed of the port, 10 Mbps, or 100
Mbps, is displayed.
Duplex Status The duplex mode is displayed, Half or
Full.
Auto negotiation
The status of the feature is displayed.
10/100 4-Port VPN Router
Advanced Configuration
Statistics
For the selected port, the Statistics table displays the
following:
Port Receive Packet Count
received is displayed.
Port Receive Packet Byte Count
bytes received is displayed.
Port Transmit Packet Count
transmitted is displayed.
Port Transmit Packet Byte Count
bytes transmitted is displayed.
Port Packet Error Count The number of packet errors is
displayed.
To update the on-screen information, click Refresh.
Firewall > General
Enable or disable a variety of firewall, security, and web
features.
Firewall > General

General

Firewall The firewall is enabled by default. If you disable
it, then the SPI, DoS, and Block WAN Request features,
Access Rules, and Content Filters will also be disabled, and
the Remote Management feature will be enabled.
SPI (Stateful Packet Inspection)
by default. The Router's firewall uses Stateful Packet
Inspection to review the information that passes through
the firewall. It inspects all packets based on the established
connection, prior to passing the packets for processing
through a higher protocol layer.
DoS (Denial of Service) This option is enabled by default.
It protects internal networks from Internet attacks, such
The number of packets
The number of packet
The number of packets
The number of packet
This option is enabled
29