Cisco RV042 - Small Business Dual WAN VPN Router User Manual page 18

Chapter 4
Static IP
Specify WAN IP Address
Enter the external IP address of
the Router.
Subnet Mask Enter the subnet mask of the Router.
Default Gateway Address
default gateway.
DNS Server (Required) 1/2
IP address. Multiple DNS server IP settings are common. In
most cases, the first available DNS entry is used.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
PPPoE (Point-to-Point Protocol over Ethernet)
Some DSL-based Internet Service Providers (ISPs) use
PPPoE (Point-to-Point Protocol over Ethernet) to establish
Internet connections for end-users. If you use a DSL
line, check with your ISP to see if they use PPPoE, select
PPPoE.
PPPoE
User Name and Password
Name and Password. The maximum number of characters
is 60.
10/100 4-Port VPN Router
Enter the IP address of the
Enter at least one DNS server
Enter your account's User
Advanced Configuration
Service Name
Enter the Service Name, if provided by
your ISP.
Connect on Demand
If you select the Connect on
Demand option, the connection will be disconnected
after a specified period of inactivity (Max Idle Time). If you
have been disconnected due to inactivity, Connect on
Demand enables the Router to automatically re-establish
your connection as soon as you attempt to access the
Internet again. Enter the number of minutes you want to
have elapsed before your Internet access disconnects. The
default Max Idle Time is 5 minutes.
Keep Alive: Interval
If you select the Keep Alive option,
the Router will send keep-alive packets as often as you
specify. The default Interval is 30 seconds.
Keep Alive: Retry Times
If you select the Keep Alive
option, the Router will send keep-alive packets as many
times as you specify. If the Router does not receive a
response from the ISP, then the Router will terminate the
connection and start sending PADI packets after the Redial
Period. The default Retry Times is 5 times.
Keep Alive: Redial Period
option, the Router will keep the connection alive by
sending out a few data packets periodically, so your ISP
thinks that the connection is still active. This option keeps
your connection active indefinitely, even when it sits idle.
The default Redial Period is 30 seconds.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
PPTP (Point-to-Point Tunneling Protocol)
Point to Point Tunneling Protocol (PPTP) is a service used
in Europe, Israel, and other countries.
PPTP
Specify WAN IP Address
Enter the external IP address of
the Router.
Subnet Mask Enter the subnet mask of the Router.
If you select the Keep Alive
11