Cisco RV042 - Small Business Dual WAN VPN Router User Manual page 60

Chapter 4
PPPoE
Complete the User Name and Password fields with the
information provided by your ISP.
Click Next to continue. Click Previous if you want to
return to the previous screen. Click Exit if you want to
exit the Setup Wizard.
PPPoE
Select Connect on demand or Keep alive. If you select
the Connect on demand option, the connection will
be disconnected after a specified period of inactivity
(Max Idle Time). If you have been disconnected due
to inactivity, Connect on Demand enables the Router
to automatically re-establish your connection as soon
as you attempt to access the Internet again. Enter
the number of minutes you want to have elapsed
before your Internet access disconnects. The default is
5 minutes.
If you select the Keep alive option, the Router will keep
the connection alive by sending out a few data packets
periodically, so your ISP thinks that the connection is
still active. This option keeps your connection active
indefinitely, even when it sits idle. The default Redial
Period is 30 seconds. The default Keepalive Interval
is 30 seconds. The default Keepalive Retry Times is
5 times.
Click Next to continue, and proceed to step 6. Click
Previous if you want to return to the previous screen.
Click Exit if you want to exit the Setup Wizard.
10/100 4-Port VPN Router
Advanced Configuration
Connect on Demand or Keep Alive
6. To set up the WAN2 port as a WAN (Internet) port,
repeat step 5. To set up the WAN2 port as a DMZ port,
go to step 7.
7. Complete the DMZ IP and Subnet Mask fields
with the information provided by your ISP.
Click Next to continue, and proceed to step 8. Click
Previous if you want to return to the previous screen.
Click Exit if you want to exit the Setup Wizard.
DMZ
53