G Network; Network Status - Acer Predator Connect X7 BE11000 User Manual

There are some limitations in our mesh which are listed below:
I. Due to the adoption of front-haul and backhaul sharing bandwidth to
connect various nodes in the Mesh network, if the Mesh agent is in a
daisy-chain configuration, each layer of connected nodes needs to
simultaneously handle communication with both upper-layer nodes and
lower-level devices. As a result, the available bandwidth speed will be
halved and evenly distributed. Based on this limitation, we recommend that
users assemble the Mesh network using Ethernet cables to connect the
nodes. This will avoid rate loss due to shared bandwidth (achieving
lossless conditions). If users must connect the nodes wirelessly, we
suggest forming a star topology network to prevent significant rate
reduction caused by multi-tiered connections.
II. All devices are factory-defaulted as CPEs. Users can change the device
role (e.g., Mesh controller, Mesh agent) through Quick Setup.
III. Once a device has been set as a Mesh controller or Mesh agent, changing
the device role requires restoring the device to its factory settings before
the role change can be made. Note: When the current device is a CPE, it
can be changed to other roles such as Mesh controller or agent (using GUI
operation mode or Quick Setup).
IV. Mesh supports WPS Onboarding, but in cases where connection is
hindered due to environmental interference, it's recommended to move the
agent closer to the controller, or restore the device to its factory default
settings and follow the Quick Setup process to reconfigure the agent.
Alternatively, you can perform the setup steps via Ethernet connection.
V. If the Mesh Wi-Fi SSID or password is changed in an existing Mesh
network, agents will apply the new configuration after the synchronization
process is done. If the agent does not apply the new configuration
successfully or the agent is in the offline status, it must go through the
onboarding process with the controller again. This is necessary for the
updated SSID or password to be applied to these agents.
7.

5G Network

7.1 5G Network Status
This tab displays key information
about 5G NR/4G LTE networks such
as:
• SIM status:
Shows verification status of your SIM.
16 16