UK: INSTRUCTION MANUAL
6. Do not open the valve beyond the point where maximum intensity is reached, as this may cause
unnecessary flaring and waste gas.
7. Do not move the appliance or gas cartridge once lit, as this may result in flaring. A warm-up period of
about 1 minute is required to avoid flaring.
8. Avoid twisting the flexible hose.
9. If the gas pressure drops or the gas will not light, check whether there is gas left in the cartridge. If
there is gas left in the cartridge, the gas temperature may be too low.
FOR YOUR SAFETY – IF YOU SMELL GAS
• If there is a leak on your appliance (smell of gas), take it outside immediately to a well-ventilated, flame-
free location where the leak can be detected and stopped.
• If you need to check for leaks on your appliance, do so outside. Do not attempt to detect leaks using
a flame; instead, use soapy water. See instructions under "HOW TO CHECK FOR LEAKS WITH SOAPY
WATER."
• If the odour persists, stop using the appliance immediately and contact the dealer or Outwell Customer
Service (contact details below).
AFTER USE AND STORAGE
1. After cooking, turn the knobs clockwise to shut off the gas supply completely, as shown in Picture F.
2. Always disconnect the gas cartridge from the regulator (12) when the appliance is not in use.
3. To disconnect the gas cartridge, twist it counterclockwise with one hand while holding the regulator
with the other, and remove the cartridge from the regulator, as shown in Picture G. Replace the
cartridge cap and store the cartridge in a safe location.
4. Let the appliance cool down completely. Fold down the windshields and close the lid, securing it with
the latch. Place the regulator and hose assembly back into their designated slot at the bottom of the
appliance. Fold the legs underneath, as shown in Picture H.
5. Store the appliance in a clean, dry place, away from direct sunlight and temperatures above 50°C.
F
Applicable for Merapi Pro Duo Deluxe (651270 / SG-203-18), or if you purchased the Merapi Pro Grill
Plate (651295)
• Ensure the grill plate (2) has completely cooled down before removing it.
• Remove the grill plate, follow the instructions under "CLEANING AND MAINTENANCE, " and store it in a
clean, dry place, away from direct sunlight.
CHANGING OR DISCONNECTING THE GAS CARTRIDGE
• Always disconnect the gas cartridge from the appliance when not in use.
• The cartridge can be disconnected or reconnected even if some gas remains.
• Ensure the appliance is completely turned off by screwing both knobs (8 + 9) fully clockwise towards
the "•" symbol.
• Be cautious, as the appliance may still be hot.
• The gas cartridge should be changed in a well-ventilated location, preferably outdoors, away from any
sources of ignition such as naked flames, pilot lights, electric fires, and away from other people.
• Carefully unscrew the gas cartridge from the adaptor (12).
• Check the contents of the cartridge by shaking it and listening for the sound of liquid gas.
• Dispose of the cartridge according to the instructions printed on it.
• To ensure a safe connection of a new gas cartridge to your appliance, please refer to the sections
"ASSEMBLY INSTRUCTIONS* and "OPERATION."
G
H
8
HOW TO CHECK FOR LEAKS WITH SOAPY WATER
• Use a soft cloth and soak it in soapy water.
• Apply a small amount of soapy water to all joints of the gas components.
• If there is a leak, bubbles will form in the soapy water.
• If you detect a leak, stop using the appliance immediately and contact the dealer or Outwell Customer
Service (contact details below).
CLEANING AND MAINTENANCE
• Regularly inspect the overall condition of the appliance and clean it as needed.
• Ensure the appliance has completely cooled down before cleaning.
• Use hot soapy water and a cloth or sponge to clean the drip tray (5).
• The interior surfaces of the appliance housing and cover should also be washed with hot soapy water.
• Regularly check the burner to ensure it is free from insects and dust that may block the gas system.
• Inspect the seals regularly to ensure they are in good condition. If there are any signs of wear and tear,
the seals must be replaced with new ones.
• For assistance, contact the dealer or Outwell Customer Service (contact details below).
Applicable for Merapi Pro Duo Deluxe (651270 / SG-203-18), or if you purchased the Merapi Pro Grill
Plate (651295)
• Use a soft cloth with warm soapy water to clean the grill plate with ceramic coating (2) to avoid
scratching the coating.
• Do not use metal utensils on the grill plate (2), as this will damage the coating.
• Discard the grill plate (2) if the coating is cracked or damaged.
TROUBLESHOOTING
No gas
supplied
Smell gas
Causes
Low flame
at MAX
at "OFF"
position
Ignition knob
is not turned to
MAX position
Ignition knob
•
•
malfunction
•
Clogged nozzle
Cartridge
•
•
incorrectly
installed
Clogged
burner holes
Bent or rusty
electrode on
the auto piezo
ignitor
•
No gas
Outwell Customer Service
e-mail: info@outwell.com
Tel.: +45 70 50 59 00
UK: INSTRUCTION MANUAL
Ignition
Flame
Troubleshooting
fails
extinction
Turn the knob fully to the
•
•
MAX position
Contact the dealer or
•
•
Outwell Customer Service
Contact dealer or Outwell
•
•
•
Customer Service
Reinstall the cartridge
correctly (See
•
"CONNECTING YOUR
APPLIANCE TO A GAS
CARTRIDGE")
•
•
Use a metal brush to clean
Clean the electrode on the
•
auto piezo ignitor
•
•
•
Replace the fuel cartridge
9
Need help?
Do you have a question about the MERAPI PRO DUO DELUXE and is the answer not in the manual?