Cisco CISCO851-K9 - 851 Integrated Services Router Configuration Manual page 99

Chapter 9 Configuring a Wireless LAN Connection
Command
Step 3
encryption method algorithm key
Example:
Router(config-if)# encryption vlan 1 mode
ciphers tkip
Router(config-if)#
Step 4 ssid name
Example:
Router(config-if)# ssid cisco
Router(config-if-ssid)#
Step 5
vlan number
Example:
Router(config-if-ssid)# vlan 1
Router(config-if-ssid)#
Step 6
authentication type
Example:
Router(config-if-ssid)# authentication open
Router(config-if-ssid)# authentication
network-eap eap_methods
Router(config-if-ssid)# authentication
key-management wpa
Step 7
exit
Example:
Router(config-if-ssid)# exit
Router(config-if)#
Step 8
speed rate
Example:
Router(config-if)# basic-1.0 basic-2.0
basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0
36.0 48.0 54.0
Router(config-if)#
Step 9 rts [retries | threshold]
Example:
Router(config-if)# rts threshold 2312
Router(config-if)#
OL-5332-01
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
Configure the Root Radio Station
Purpose
Specifies the encryption method, algorithm, and
key used to access the wireless interface.
The example uses the VLAN with optional
encryption method of data ciphers.
Creates a Service Set ID (SSID), the public
name of a wireless network.
All of the wireless devices on a WLAN
Note
must employ the same SSID to
communicate with each other.
Binds the SSID with a VLAN.
Sets the permitted authentication methods for a
user attempting access to the wireless LAN.
More than one method can be specified, as
shown in the example.
Exits SSID configuration mode, and enters
interface configuration mode for the radio
interface.
(Optional) Specifies the required and allowed
rates, in Mbps, for traffic over the wireless
connection.
(Optional) Specifies the Request to Send (RTS)
threshold or the number of times to send a
request before determining the wireless LAN is
unreachable.
9-3