Cisco CISCO851-K9 - 851 Integrated Services Router Configuration Manual page 50

Configure the Dialer Interface
Command
Step 7
dialer-group group-number
Example:
Router(config-if)# dialer-group 1
Router(config-if)#
Step 8
exit
Example:
Router(config-if)# exit
Router(config)#
Step 9 dialer-list dialer-group protocol protocol-name
{permit | deny | list access-list-number |
access-group}
Example:
Router(config)# dialer-list 1 protocol ip
permit
Router(config)#
Step 10 ip route prefix mask {interface-type
interface-number}
Example:
Router(config)# ip route 10.10.25.2
0.255.255.255 dialer 0
Router(config)#
Repeat these steps for any additional dialer interfaces or dialer pools needed.
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
4-4
Chapter 4 Configuring PPP over ATM with NAT
Purpose
Assigns the dialer interface to a dialer group
(1–10).
Tip Using a dialer group controls access to
your router.
Exits the dialer 0 interface configuration.
Creates a dialer list and associates a dial group
with it. Packets are then forwarded through the
specified interface dialer group.
For details about this command and additional
parameters that can be set, see the Cisco IOS Dial
Technologies Command Reference.
Sets the IP route for the default gateway for the
dialer 0 interface.
For details about this command and additional
parameters that can be set, see the Cisco IOS IP
Command Reference, Volume 1 of 4: Routing
Protocols.
OL-5332-01