Cisco CISCO851-K9 - 851 Integrated Services Router Configuration Manual page 101

Chapter 9 Configuring a Wireless LAN Connection
Command or Action
Step 3
bridge-group number
Example:
Router(config)# bridge-group 1
Router(config)#
Step 4
bridge-group number parameter
Example:
Router(config)# bridge-group 1
spanning-disabled
Router(config)#
Step 5
interface name number
Example:
Router(config)# interface bvi 1
Router(config)#
Step 6
bridge number route protocol
Example:
Router (config) # bridge 1 route ip
Router(config)#
Step 7 ip address address mask
Example:
Router(config)# ip address 10.0.1.1
255.255.255.0
Router(config)#
Repeat
OL-5332-01
Step 2 through Step 7 above for each VLAN that requires a wireless interface.
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
Configure Bridging on VLANs
Purpose
Assigns a bridge group to the interface.
Sets other bridge parameters for the bridging
interface.
Enters configuration mode for the virtual bridge
interface.
Specifies the protocol for the bridge group.
Specifies the address for the virtual bridge
interface.
9-5