Cisco CISCO851-K9 - 851 Integrated Services Router Configuration Manual page 136

Configuring Dial Backup and Remote Management Through the ISDN S/T Port
Perform these steps to configure your router ISDN interface for use as a backup interface, beginning in
global configuration mode:
Command
Step 1 isdn switch-type switch-type
Example:
Router(config)# isdn switch-type basic-net3
Router(config)#
Step 2 interface type number
Example:
Router(config)# interface bri 0
Router(config-if)#
Step 3 encapsulation encapsulation-type
Example:
Router(config-if)# encapsulation ppp
Router(config-if)#
Step 4 dialer pool-member number
Example:
Router(config-if)# dialer pool-member 1
Router(config-if)#
Step 5 isdn switch-type switch-type
Example:
Router(config-if)# isdn switch-type
basic-net3
Router(config-if)#
Step 6 exit
Example:
Router(config-if)# exit
Router(config)#
Step 7 interface dialer dialer-rotary-group-number
Example:
Router(config)# interface dialer 0
Router(config-if)#
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
13-18
Chapter 13 Configuring Dial Backup and Remote Management
Purpose
Specifies the ISDN switch type.
The example specifies a switch type used in
Australia, Europe, and the United Kingdom. For
details on other switch types supported, see the
Cisco IOS Dial Technologies Command
Reference.
Enters configuration mode for the ISDN Basic
Rate Interface (BRI).
Sets the BRI0 interface encapsulation type.
Specifies the dialer pool membership.
Specifies the ISDN switch type.
Enters global configuration mode.
Creates a dialer interface (numbered 0–255) and
enters interface configuration mode.
OL-5332-01