Magtek DynaFlex II SCR Device Manual page 2

Quick Inspection
As part of your inspection, include the following for your device inspection
audit:
•
Be certain to have a list of the devices and include the details listed on
the product label.
•
It may be helpful to take photos of the front, back, and side of each device.
Be certain to check device part numbers, serial numbers and IDs and
check physical connections. Use the chart below as a checklist to inspect
the device for signs of tampering.
Site Inspection
Form Factor - check overall form factor
Front
Tap landing pad
Magnetic stripe swipe path
EMV contact card slot
Barcode reader (when applicable)
Sides
Magnetic stripe swipe path
Rubberized shell
Form factor
Cables and charging cradle
USB-C cable
Underside and Back
Certificate logos imprinted
Form factor
Cable connection
Pushbutton
Charging contacts
Labels
Tripped device
If there is forced entry, the security switches built
into the electronics will be tripped. If they are tripped
the sensitive data such as encryption keys and
certificates are cleared as part of security measures
mandated by PCI and the device will not be
available to make transactions.
NOTICE:
If the security switches have been tripped, DynaFlex II PED products
cannot be repaired in the field and must go back to the factory for repair.
Follow RMA procedures. User must report all signs of tampering as per
standard protocol.
Inspection of Sides, Point of Installation, and Checklist Summary
Are there signs of tampering: Signs of tampering
YES
MagTek Inc., 1710 Apollo Court, Seal Beach CA 90740 | p 562-546-6400 | support 562-546-6800 | www.magtek.com
®
Certifications and Validation
PCI DEVICE VALIDATION
To check for PCI Validation check the Hardware and Firmware ID.
Hardware ID is printed on the label.The Firmware ID is accessible via
the device and displayed on the screen. Go to the PCI compliance web
page and search for MagTek, and find the product name, DynaFlex II.
Compare the Hardware ID and Firmware ID:
https://www.pcisecuritystandards.org/assessors_and_solutions/pin_transaction_devices
FEATURES
NO
Some features and functions may be documented, but not available with the current release of
the product. Please contact your MagTek representative for questions about specific features
and functions and when they are scheduled to become available.
TRADEMARKS
EMV® is a registered trademark in the U.S. and other countries and an unregistered trademark
elsewhere. The EMV trademark is owned by EMVCo, LLC. The Contactless Indicator mark,
consisting of four graduating arcs, is a trademark owned by and used with permission of
EMVCo, LLC.
EU STATEMENT
Hereby, MagTek Inc. declares that the radio equipment types Wideband Transmission System
(Wireless LAN and Bluetooth Low Energy), and Non-Specific Short Range Device (contactless)
are in compliance with Directive 2014/53/EU. The full text of the EU declarations of conformity is
available at the following internet addresses:
• https://www.magtek.com/Content/DocumentationFiles/D998200573.pdf
UKCA STATEMENT
Hereby, MagTek Inc. declares that the radio equipment types Wideband Transmission System
(Wireless LAN and Bluetooth Low Energy), and Non-Specific Short Range Device (contactless)
are in compliance with Radio Equipment Regulations 2017 Directive S.I.2017:1206. The full text
of the UKCA declarations of conformity is available at the following internet addresses:
• https://www.magtek.com/Content/DocumentationFiles/D998200573.pdf
MAGTEK: Registered to ISO 9001:2015 © Copyright 2024 MagTek, Inc. PN D998200563 rev. 110 10/24