Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Patpet B110 S
Summary of Contents for Patpet B110 S
- Page 1 Anti-bark collar Patpet B110 S User manual...
-
Page 2: Important Safety Information
Thank you for choosing our anti-bark collar. Our anti-bark collar is backed by a 100% quality guarantee! If you are not satisfied for any reason, please contact our customer service immediately and we will help you within 24 hours. Important safety information Not suitable for aggressive dogs Do not attempt to use this product to correct the behavior of dogs that are aggressive towards people or other animals. -
Page 3: Main Functions
Main functions It is an improved anti-bark dog collar with a digital display and four buttons - power, vibration, shock and sensitivity button. Digital display Shock button Power button - stage 0-7, stage 7 means fully charged Switching on and off Button for sensitivity Vibration button Vibration button -- Level 0-7, level 7 means the highest... - Page 4 ON-OFF One press of the power button turns it on. Pressing the power button again for 3 seconds will turn it off. * Once you receive the collar, test it first (testing is shown below). * After testing, please set the appropriate mode for your dogs and follow the instructions that apply to your current situation! (picture with instructions below) * We recommend that you do not use the shock model at first and choose the beep and vibrate mode so that your dog gets used to it.
- Page 5 The principle of operation of the product This product uses vibration sensors to differentiate sensitivity. When the dog barks, the sensors are triggered and so is the product. The collar emits an audible signal, then a vibration and finally a shock. (depending on the setting). Automatic protection mode If the collar is activated 7 times within one minute, it will enter the automatic protection mode and "E"...
- Page 6 Testing Switch on the device Set the sensitivity to level 5-7 and the impact higher than 0. Wear the tester on the conductive silicone tabs behind the collar. Speak into the collar and say "woof" (as short as possible) to trigger the sensors. Since the Sensors frequency of the human voice is different from the frequency of the dog's voice, try again.
- Page 7 Attention: Question: On which part of the dog's body can the receiver be placed? Answer. Keep a distance of one finger between the neck and the collar. to avoid triggering when shaking/moving/running etc. Please remove the normal collar before putting on the anti-bark collar.
- Page 8 Tips You should choose these features according to the size of your dogs. For detailed instructions on which size to choose, please refer to the dog size reference chart. The degree of sensitivity most suitable for your dog. You can put the collar on the dogs without turning on the device so that they can adapt to the collar.
- Page 9 The device has been approved for use in EU countries and is therefore provided with the CE All necessary documentation is available on the website: www.electric-collars.com mark. Changes to technical parameters, properties and printing errors reserved. Service center and distribution Reedog, sro Sedmidomky 459/8 101 00 Prague 10...
Need help?
Do you have a question about the B110 S and is the answer not in the manual?
Questions and answers