A minute current is supplied to each electrode bar installed in the tank, and the current Principle flows when the conductive measurement reaches the electrode bar. The control unit detects this current signal and outputs a contact signal. HITROL CO., LTD.
Control + 2-Alarms 4-Alarms AC 250V, 5A / AC 250V, 5A / AC 250V, 10A / Contact Rating DC 30V, 1A DC 30V, 5A DC 30V, 10A HE-Series is recommended for use with our Control Unit . HITROL CO., LTD.
- Open the product COVER and insert the CABLE through the wire inlet. - Cables at desired contacts (E1, E2…).) and finish. - Please refer to the picture below for the connection with the control unit . HITROL CO., LTD.
■ If it is for high temperature, it may burn, so it should be separated using gloves. ■ Demolition work should be done with the power off. ■ Be careful not to damage the O-ring or gasket when opening and closing the COVER of the product. HITROL CO., LTD.
(The HE-S Series only displays the model sticker on the top of the housing and the serial number on HE- V Series Sticker HE- H Series Nameplate HE- H-S/SP Series Nameplate HITROL CO., LTD.
You can apply for aftersales service through the website or the headquarters. ■ Contact Address: 141 Palhakgol-gil , Jori-eup, Paju-si, Gyeonggi-do ( 98) High Roll HITROL CO., LTD 141, Palhakgol-gil, Jori-eup, Paju-si, Gyeonggi-do, Korea TEL : 031-950-9700 (head office and A/S) FAX: 031-943-5600 (head office and A/S)
Need help?
Do you have a question about the HE Series and is the answer not in the manual?
Questions and answers