To Trim And Edge; Fault Finding Chart - Flymo MULTITRIM 250D Manual

WARNING: The use of eye protection is recommended.
Do not lean over the trimmer whilst trimming or edg-
ing, objects may be thrown by the cutting line. Do not
allow cutting head to rest on the ground. Do not over-
load your trimmer. Overloading can be avoided by
making sure the motor speed does not drop unduly.
Disconnect from the mains electricity supply before
attempting any maintenance or adjustment.
BEFORE USE: Make sure that the line is fed out (if 2
lines are fitted, make sure both are fed out).
Make sure motor is up to full speed before trimming
or edging.
How to trim
(M)
How to edge
See Fig N.
Q.
R.
Please note: Depending on which model you have
purchased, your trimmer may be fitted with a roller
or a skid plate.
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS CONTINUOUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
How to Trim and Edge
Fig K
See Fig L
Fig K
P

Fault Finding Chart

Contact Electrolux Outdoor Products Customer Service
Telephone : 01325 300303
K
M
N
Q
See Fig
CHECK
L
P
R
ACTION
No
SEE "MANUAL LINE FEED"
No
"SPOOL CAP AND NYLON LINE"
No
No
Yes
SEE "MANUAL LINE FEED"
Contact your local approved Service
Yes
Centre or Electrolux Outdoor
Products Customer Service.
?
SEE "How to trim and edge"
Yes
4
SEE