Extreme Networks Alpine 3802 Hardware Installation Manual page 129
Consolidated “i” and “e” series
Hide thumbs
Also See for Alpine 3802:
- Installation note (3 pages) ,
- Hardware manual (352 pages) ,
- Hardware installation manual (330 pages)
Table of Contents
Advertisement
1 On a Summit switch with a power switch, turn off the power supply by setting the power switch to
the OFF position.
2 Disconnect the power cable from the power source and then from the Summit switch.
3 If necessary (for example, on a Summit 1i or Summit 5i), remove the two retaining screws from the
power socket on the rear of the switch using a #2 Phillips screwdriver.
Keep the screws for future use.
4 Slide the retaining bracket over the power cable, as shown in Figure 68 or Figure 70.
If necessary, loosen the retaining bracket screw.
5 Connect the power cable to the switch
CAUTION
Do not connect the power cable to the power source at this time.
Figure 68: Attaching the retaining bracket directly
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Retaining bracket screw
Installing the AC Power Cable Retaining Bracket
LB48021B
129
Hide quick links:
Advertisement
Table of Contents
Related Manuals for Extreme Networks Alpine 3802
Related Products for Extreme Networks Alpine 3802
- Extreme Networks Alpine 3800 FM-24MFi
- Extreme Networks Alpine 3800 FM-32Ti
- Extreme Networks Alpine 3800 GM-16T3
- Extreme Networks Alpine 3800 GM-4Xi
- Extreme Networks Alpine 3800 Series
- Extreme Networks Extreme Switching ERS 3510GT-PWR+
- Extreme Networks Extreme Switching ERS 3549GTS
- Extreme Networks Extreme Switching ERS 3549GTS-PWR+
- Extreme Networks Extreme Switching ERS 3550T-PWR+
- Extreme Networks ExtremeSwitching ERS 3626GTS
- Extreme Networks ExtremeSwitching ERS 3626GTS-PWR+
- Extreme Networks ExtremeSwitching ERS 3650GTS
- Extreme Networks ExtremeSwitching ERS 3650GTS-PWR+
- Extreme Networks 31016
- Extreme Networks 31017
- Extreme Networks 16519