Seiwa LZIP79 Instruction Manual

Instruction Manual
Thank you very much for purchasing our LED lighting fittings.
Please read this instruction manual to use the product properly.
After installing the product, be sure to hand this manual over to the user of the product.
Prior to use
1) Prior to installing the fitting, check if the product is as per your order.
2) Check for a loose or damaged part due to an accident in transit, etc.
Performance
1) The electrical characteristic data is given below.
Average Color
Model
rendering index
LZIP79
LZIP60 Ra73
LZIP37
2) Usable in hazardous sreas of zone 1 or zone 2, zone21, zone22 hazardous areas.
Names of the Components and Installation Method
- Installation work should be done properly by a qualified electrician in accordance with the related laws and the instruction manual.
- For safety, Installation work should be done by at least two workers.
- Related laws and regulations refer to the Industrial Safety and Health Act and the Electrical Equipment Technical Standards.
■ Direct Mount Type, Pipe Pendant Type, Bracket Type
Hanging Hook Hole ④
③⑤⑥
Junction Box Lid
⑥
4-Cross Recessed Hex Bolt
Suspension ②③
Pipe
Explosion proof type LED Lighting Fittings
Input Voltage
Installation Type
Direct mount
Pipe pendant
Bracket
Floodlight
Stanchion type
Pole B type, C type
Highway type
Special Direct Mount type
Replacement demand
4-φ8 Mounting Holes
Junction Box ①④⑥⑦
Lid Packing
Suspension Hook ④⑤
4-Locking Screws
Retainer ②
Fitting ④⑦
Fig. 1
Input
(Frequency) Current
0.81-0.34A
100-242V AC
0.61-0.265A
(50/60Hz)
0.375-0.18A
①
Securely attach the junction box to a horizontal mounting surface
using M6 bolts or bolts of equivalent strength.
For the bracket type, fix it on a vertical mounting surface
NB:
securely.
②
Screw the pipe into the retainer.
③
Screw the junction box lid onto the suspension pipe.
④
Lift the fitting and hook the hanging hook into the hanging hook
hook hole of the junction box.
⑦
⑤
After connecting the lamp power cable (black/white: power line,
green: ground line), remove the suspension hook from the hook
hole and store it in the junction box lid.
⑥
Attach the junction box cover to the junction box using the four
cross-recessed hex bolts.
⑦
After adjusting the rotational position of the fitting and junction box,
tighten the set screws (3 locations) to secure them.
NB1: Use tools to securely tighten the hanging pipe, locking screw, and
cross-recessed hex bolt. Insufficient tightening may cause the
device to fall.
NB2: Caulk the threaded connections.
NB3: For the bracket type, the lamp house may be installed within an
angle range of 0° (down) to 45° (oblique).
For the direct mount and Pipe pendant type, The lamp house
may be installed within an angle range of 0° (down).
- 1 -
LZIP
Power IP Type of
Consumption rating protection
79.5-77.5W
Ex eb mb ⅡC T5
59.5-59.0W IP65
Ex tb ⅢC T85℃
36.5-37.5W
11E0200798A11
To be conserved
Option
-Guard
-Glare cut
Gb
panel
-Fall
prevention
Db
wire