Using The Remote Control With A Signal Cable; Switching The Remote Control Mode - Eiki EIP-WX5000 Owner's Manual

Using the Remote Control with a Signal Cable

When the signals from the remote control cannot be reached due to the positioning of the projector, use a
ø3.5 mm minijack cable to connect the remote control to the projector. Now you can control the projector
with the remote control.
Rear view
Note
• The wireless remote function is not possible when the ø3.5 mm minijack cable is connected to the projec-
tor. Should the wireless remote operation be required, the ø3.5 mm minijack cable should be discon-
nected from the projector.

Switching the Remote Control Mode

The remote control has two functions. One is projector control and the other is wireless computer mouse.
Slide the ADJ./MOUSE switch on the remote control to other side compatible to the desired usage.
Info
• When using the remote control as the wireless computer mouse, connect the supplied remote receiver to
the computer. (See page 18.)
To WIRED REMOTE terminal
ø3.5 mm minijack cable (commercially available)
Projector control
ADJ.
MOUSE
Remote control
To WIRED R/C JACK
Wireless computer mouse
ADJ.
MOUSE
17