Eagle FishEasy 245DS Portable Installation And Operation Instructions Manual page 16

4. Drilling mounting holes. Hold the transducer and bracket assem-
bly against the transom. The transducer should be roughly parallel to
the ground. The transducer's centerline should be in line with the bot-
tom of the hull. Don't let the bracket extend below the hull!
Mark the center of each slot for the mounting screw pilot holes. You
will drill one hole in the center of each slot.
Drill the holes. Use the #29 bit (for the #10 screws).
Metal
Nut
washer
Rubber
washers
Assemble transducer and bracket.
12
Metal washer
Bolt