Table of Contents
Advertisement
Configuring the MCU MSE 8510
Step one: Log in to the MCU MSE 8510
All administration of the MCU MSE 8510 is performed via the web interface.
To log in to the web interface of the MCU MSE 8510 :
1
Log in to the Supervisor's web interface.
2
Go to
Hardware > Blades
3
Click
Log in
information page
Cisco recommends that you change the admin account to use a password
i
as soon as possible. To do that, click
information
required user information.
Step two: Allocate port licences
Port licenses must be allocated to the MSE 8510 from the Supervisor's
page. Where the MSE 8510 is supporting high definition conferencing, each port
requires more than one port license. Refer to the online help for assistance.
Step three: Using an H.323 gatekeeper or SIP registrar
(optional)
If you have H.323 endpoints, using an H.323 gatekeeper can make it easier for
participants to call in to a conference. You can configure the MCU MSE 8510 to use
an external gatekeeper or its own built-in gatekeeper. For information about using
the built-in gatekeeper, refer to the online help.
If you have SIP endpoints, using a SIP registrar can make it easier for participants to
call in to a conference.
To configure the MCU MSE 8510 to use an H.323 gatekeeper:
1
In the web interface of the MCU MSE 8510 , go to
2
Enable
H.323 gatekeeper usage
the online help for further assistance.
3
Click
Apply changes
and click the IP address of the MCU MSE 8510.
and enter the user name
is displayed.
page or go to
.
Configuring the MCU MSE 8510
with no password. The
admin
Change password
, click the
Users
admin
and configure the settings you require, using
Login
on the
Login
link, and provide the
Port licenses
.
Settings > H.323
9
Advertisement
Table of Contents
