Cisco 2505 Getting Started Manual page 30

Note Press the hyphen key if you need to return to the previous command line.
Table 3 Startup Wizard Information
Wizard Setting
System Name
Administrative user name
Administrative password
Management Interface IP Address
Management Interface Netmask
Management Interface Default Router
Management Interface VLAN Identifier
Management Interface Port Num [1 to 4]
30
Action
Enter the system name, which is the name you
want to assign to the controller. You can enter up
to 31 ASCII characters.
Enter the administrative user name to be assigned
to this controller. You can enter up to 24 ASCII
characters for each.
The default administrative username is admin.
Enter the administrative password to be assigned
to this controller. You can enter from 3 to 24
ASCII characters for each.
Note There is no default administrative
password, you must enter a password.
Enter the IP address of the management interface.
The management interface is the default interface
for in-band management of the controller and
connectivity to enterprise services such as AAA
servers.
You can access the controller GUI interface using
the management interface IP address.
Enter the IP address of the management interface
netmask.
Enter the IP address of the default router.
Enter the VLAN identifier of the management
interface (a valid VLAN identifier or 0 for an
untagged VLAN).
The VLAN identifier should be set to match the
switch interface configuration.
Enter the port number of the access point
manager interface. Ports values are 1 to 4.