Cisco 2505 Getting Started Manual page 32

Table 3 Startup Wizard Information (continued)
Wizard Setting
Allow Static IP Addresses
Configure a RADIUS Server Now?
Enter Country Code List
Enable 802.11b Network
Enable 802.11a Network
Enable 802.11g Network
Enable Auto-RF
Configure a NTP server now?
Enter the NTP server IP address
32
Action
Enter YES to allow clients to assign their own IP
address or no to make clients request an IP
address from a DHCP server. Values are YES or
no. The default setting is YES.
If you select YES, you are prompted to enter the
following:
• RADIUS server IP address
• RADIUS server port (default port is 1812)
• RADIUS server secret
If you select no, the following message appears:
Warning! The default WLAN security policy
requires a RADIUS server. Please see
documentation for more details.
Enter the two letter country code. The default
country code is the United States (US). Enter
'help' to see a list of countries.
Choose YES to enable or no to disable the
802.11b radio network. The default is YES.
Choose YES to enable or no to disable the
802.11a radio network. The default is YES.
Choose YES to enable or no disable the 802.11g
radio network. The default is YES.
Choose YES to enable or no to disable radio
resource management. The default is YES.
Enter YES to configure an NTP server. The values
are YES or no. The default value is YES.
Enter the NTP server IP address.
This prompt only displays if YES was
Note
entered in the "Configure a NTP Server
Now?" prompt.