Cisco 1720 Hardware Installation Manual page 47

Chapter 2 Installing the Cisco 1700 Router
If you install the screws in drywall, use hollow wall anchors (1/8 inch
Caution
by 5/16 inch) to secure the screws. If the screws are not properly anchored, the
strain of the cables connected to the router rear-panel connectors could pull the
router from the wall.
78-5405-03
Hang the router on the screws with either the left side or
Step 2
right side mounting brackets so that:
•
The LEDs are visible to the user—The LEDs
indicate the router operating status, so the LEDs
should be easily visible.
•
The power supply does not hang from its cable—If
the power supply is not supported, it might
disconnect from the cable that connects it to the
router.
Cisco 1700 Router Hardware Installation Guide
2-15