Connecting Network Cable; Ac Power - TRENDnet TPE-S88 User Manual

Connecting Network Cable

The Switch support 16 10/100M Ethernet ports and Port 1 ~ port 8 are
PoE Enable ports, these PoE port will automatically activated when a
compatible terminal is identified, the Switch will supply power
through the Ethernet port to the connected PoE device.
For the Legacy devices that are not yet compatible, the PoE port will
not offer the power to this device. This feature allows users to freely
and safely mix legacy and Power over LAN compatible devices on
their network.
The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and
it runs both in half and full duplex mode using two pair of Category 5
cable.
These RJ45 ports are Auto-MDI type port. The Switch can auto
transform to MDI-II or MDI-X type, so you can just make an easy
connection that without worrying if you are using a standard or
crossover RJ45 cable.

AC Power

The Switch used the AC power supply 100-240V AC, 50-60 Hz. The
power switch is located at the rear of the unit adjacent to the AC
power connector and the system fan. The switch's power supply will
adjust to the local power source automatically and may be turned on
without having any or all LAN segment cables connected.
9