Dhcp; Relocate Http Port Number; Tag Vlan Management Group ( Cpu Port ) - TRENDnet TPE-80WS User Manual

2.1.1.2 DHCP

The default DHCP is off, so Default IP or user defined IP is used when this machine is
turning-ON, but if this switch needs an IP assigned from DHCP server, user may click the square
field and then press " Apply " to get an IP which will be assigned by DCHP server ". User must
be aware that if he enable DHCP from web page, and if the DHCP server is working, then after
enable DHCP, he will lose contact of web page, because the IP address has been changed.

2.1.1.3 relocate HTTP port number

The default port number of
switch if he knows the IP of this switch, network manager may relocate this port number to other
value, from 1024 to 65535, the same idea as above, once network manager change the value of
HTTP's port number, he will lost contact and he must regain web page by command modified as
below:
http://192.168.223.100:port_value

2.1.1.4 Tag VLAN management group ( CPU port )

At first time you turn on this device, all ports belong to default VLAN ID group (VID=1), so
they can communicate to each other, and hence any port can be used as web management port to
talk with CPU port inside, but, for example, assume user uses port 1 as web management port,
then user create VLAN ID=10 on port 7,8 and create another VLAN ID = 20 on port 5,6, now 3
VLAN groups will be shown on VALN group table after he press " Apply " button. If VLAN 10
and VLAN ID 20 must be isolated, then user must delete member port 5,6,7,8 in default VLAN
group( VID = 1 ). Be aware that CPU port is still remain on VID=1 group now, user can only
perform web management through one of 4 ports, that is port 1,2,3,4, but if user want to perform
web management from other port in
=10, then at this moment, he must go to system configuration page, and select
Management Group
management port ) from port 1 to port 8, then user can perform web management from new
RJ-45 port again. But if user forget what group that CPU belongs to, there are two ways to solve
this condition below.
(1) Through console port, change VLAN ID of CPU port if he gets password, or
(2) Press "Reset" button
---- >> IP address=192.168.223.100; ... VID=1, all settings return to factory default
HTTP command
existing
to 10, then, press
few seconds, let system return to default settings, that is,
is 80, but unauthorized user may intrude this
different VLAN group, for example port 8 in VID
" Apply " command, then move RJ-45 ( web
8
Tag VLAN