Web Management - TRENDnet TPE-80WS User Manual

2.0 Web management

After login is successfully validated, the switch's home page will show up. The left part on the
page provides the function menus, while the right part provides the individual configuration
value or system parameters value. Functions are divided into three categories, they are
Configuration, Monitoring and Maintenance; all functions are shown briefly below
Configuration
System – system values, such as H/W, F/W version, IP, IP mask, MAC address...etc
Ports – port status and configure port parameters
Port-based VLAN – to setup the port-based VLAN
Tag-based VLAN – to configure the tag-based VLAN
Port Trunking – to build up the trunk function
Port Mirroring – to setup the port mirroring function
Quality of Service – to configure the Quality of Service function
Storm Control – to set all kinds of storm limit
LACP – to set LACP parameter
RSTP – to set RSTP parameter
IGMP – to set IGMP parameter
802.1X – to set 802.1X parameter
Monitoring:
Port Statistics – to statistic traffic on each ports
Detailed Port Statistics – to statistic more detailed traffic on each ports
LACP status – to show LACP status
RSTP status – to show RSTP status
IGMP status – to show IGMP status
Reset – to reboot the switch with/without writing default configurations
Ping – provide ping function and ping result
Maintenance
Warm Reboot – to restart system
Factory Default – to get parameter value back to factory default
Firm Upgrade – to upgrade code
Config File – to backup configuration data
Logout – to logout
6