1. Before You Start Package Contents TEW-691GR Multi-Language Quick Installation Guide CD-ROM (User’s Guide) Cat. 5 Ethernet cable (1.5m / 4.9ft) Power Adapter (12V DC, 1A) System Requirements A computer with a wired or wireless network adapter properly installed. Web Browser: Internet Explorer (6.0 or higher) Broadband Internet Installed Cable or DSL Modem...
(e.g. Internet Cable/DSL Modem Explorer) and type in a URL (e.g. http://www.trendnet.com) in the address bar. 2. Power down your Cable or DSL modem and disconnect the RJ-45 cable from your computer to the TEW-691GR's WAN port. The other end of the cable should remain connected to your Cable or DSL modem.
3. Configure the wireless router Note: It is recommended that you configure the Wireless Router from a wired computer. 1. Open your web browser, type http://192.168.10.1 in the Address bar, and then press Enter. 2. Enter the User Name and Password, and then click OK.
Pre-Shared Key. You would have to know this key to wirelessly connect to the TEW-691GR. 7. Open up your browser and enter in a URL (e.g. www.trendnet.com) to verify that you have Internet connection. Your Configuration is complete For detailed information regarding the TEW-691GR’s configuration and advanced settings, please refer to the Troubleshooting section, User's Guide on the Utility CD-ROM, or TRENDnet's website at http://www.trendnet.com.
Troubleshooting 1. I typed http://192.168.10.1 in my Internet Browser's Address Bar, but an error message says “The page cannot be displayed.” How can I get into the TEW-691GR's web configuration page? Check your hardware settings again by following the instructions in Section 2. 2.
Page 8
2. Make sure to use a Cat-5e or Cat 6 Ethernet cable. Some CAT-5 cables are not rated to run in Gigabit. If you still encounter problems or have any questions regarding the TEW-691GR, please contact TRENDnet's Technical Support Department.
Need help?
Do you have a question about the TEW-691GR and is the answer not in the manual?
Questions and answers