Radio Operation - Aiwa CDC-X30MP Operating Instructions Manual

Setting the beep tone
1
Turn off the unit.
2
Press and hold SEL until "BEEP" appears on the
display.
3
Turn Jog dial to select ON or OFF.
4
Press SEL.
Setting the clock
1
Press and hold DSPL until the clock indicator
flashes on the display.
2
Press + (to set hour) or - (to set minute), and
then turn Jog dial.
3
Press DSPL.
Displaying the clock
1
Press DSPL.
To return to the former display, press DSPL again.

RADIO OPERATION

Tuning in to a station
(Seek/Manual Tuning)
+ / -
TU (TUNER)
Band indication*
Local indicator
Tuner indicator
* "F" means FM.
"A" means AM.
LO
Frequency indication
Stereo indicator
1
Press TU (TUNER) repeatedly to select the desired
band (F1, F2, F3, A1, or A2).
2*
Press + (to move to higher frequencies) or - (to
move to lower frequencies) to tune in to a station.
"ST" appears on the display when an FM station is
broadcasting in stereo, and receiving conditions are
good.
*Seek Tuning and Manual Tuning
• Press and hold + or - until Seek Tuning starts.
The unit locates a station automatically (Seek Tuning).
To stop Seek Tuning, press + or - again.
• Press + or - repeatedly to search for a desired station
while increasing or decreasing the frequency step by
step (Manual Tuning).
Monaural mode
When FM signals become weak, or FM reception
becomes poor, the unit automatically switches to
Monaural mode to reduce noise.
Local mode
Local mode allows you to tune in only to strong stations
during Seek Tuning.
1
Press LO before you start seek tuning.
"LO" appears on the display.
To return to Distant mode, press LO again.
"LO" disappears and the unit tunes in to all receivable
stations.
Using preset stations
You must preset stations before you can tune in to a
station using preset station number buttons.
+ / - TU (TUNER)
PS/A.ME
Preset station buttons 1 to 6
Preset station number
ENGLISH
4