Table of Contents
Advertisement
3. Hardware Installation
Front Panel
The front panel provides LED's for device status. Refer to the following table for the meaning of each
feature.
LED
PWR/STAT
Link
Active
Rear Panel
The rear panel features 1 LAN ports and Reset button. Refer to the following table for the meaning of
each feature.
Power (DC 5v)
Reset
LAN
AP Default Settings
The default settings are shown following.
User
Password
AP IP Address
AP Subnet Mask
RF ESSID
11g RF Channel
Mode
Encryption
User's Guide
STATUS Description
Off
No power
1. Power on 2. Reset to default 3. Firmware upgrade (first 1
Green On
minute)
Green
1. System up 2. Power on 3. Firmware upgrade
Blink
Off
no Ethernet link detected
Green On 10/100Mbps Fast Ethernet link detected. No activity.
Green
Indicates data traffic on the 10/100 Mbps LAN
Blink
Green
Indicates the device is linking or active data through wireless
Blink
links
Used to connect to the power outlet. Only use the power
adapter provided with the device. Use of an unauthorized
power adapter may cause damage to your device and
violate your warranty.
Press the Reset Button for approximately ten seconds, all
configurations will set to factory default settings.
The RJ-45 Ethernet ports used to connect your PC, hub,
switch or Ethernet network.
admin
admin
192.168.1.250
255.255.255.0
ap11g
6
11b+g
Disabled
5
Advertisement
Table of Contents
