Husky 06811 Installation Instructions Manual

Ford F150 & Lincoln Mark LT - Part #06811
INTRODUCTION
This HuskyShield product is a Clear Overlay Paint Protection (COPP)
system. Each HuskyShield "Kit" is comprised of a clear protective
fi lm with a self adhesive back. The kit is computer cut to fi t your ve-
hicle and designed to guard it's fi nish against damage from fl ying
road debris. It will provide this protection unobtrusively without
obscuring your vehicle's appearance.
KIT SHADOW SHEET
The graphic below is a "Shadow Sheet" The graphic below is a "Shadow Sheet" showin The graphic below is a "Shadow Sheet" showin
HuskyShield kit. Use this to assist you in identifying Use this to assist you in identifying Use this to assist you in identif
tion.
Front Door Edge Guards
Rear Door Edge Guards
TOOLS & SUPPLIES
Supplied with your installation kit (Part #07999): (sold separately)
A. Application Card (Part #07998)
B. Installation Solution (Part #07997)
(2 provided, only 1 needed per installation)
C. Spray Bottle (Part #07996)
D. Surface Prep Putty (Part #07995)
Huskyshield Kit
B. Installation Solution
D. Surface Prep Putty
Supplied by you:
Bathroom Scale (optional - to assist in applying proper pressure)
Blow Dryer
Quality Paper Towels, Lint Free Cloth or Chamois
Sharp Scissors
Form #I06811 r1.0
Installation Instructions
g the position and shape of your
the various pieces during installa-
Hood
C. Spray Bottle
A. Application Card
PRE-INSTALLATION PREPARATIONS
1) Verify that you have the correct "Kit" and contents for the specifi c
vehicle on which the COPP will be installed. If not, please contact
Husky Liners at 800-344-8759.
2) Read all instructions in their entirety before beginning installation.
3) Verify that you have the necessary tools and supplies.
4) Your installation environment should be free of air born dust &
debris and off er good lighting. A well lit garage with the doors
closed would be a good choice.
5) Vehicle should be completely washed prior to installation.
6) You may wish to have a scale on hand to "get a feel" of how much
pressure to apply when directed in the instructions.
ADVISORY NOTES
1) The COPP photographs included herein have had the edges
enhanced for visibility in the instructions. Your COPP edges will be
clear.
2) Allow up to an hour for installation of this kit.
3) Always keep your hands wet when handling the COPP.
DEFINITIONS
Adhesive Side - the side of the COPP that is applied to the vehicle
surface.
Bubbles - Either excess water, solution or air that becomes trapped
between the COPP and vehicle surface.
Dips - Indented areas in the contour of the vehicle surface.
Fingers - A raised area or "bunching" of COPP that resists staying down
on the vehicle's surface due to the vehicle's contour (usually on a
Hump) due to an abundance of COPP.
Gaps - A raised area of "taught" COPP that resists staying down on the
vehicle's surface due to the vehicle's contour (usually in a Dip) due
to an insuffi cience of COPP.
Humps - Raised areas in the contour of the vehicle surface.
Tack - When you squeegee a small area of the COPP so that the adhe-
sive side of the COPP is adhered to the vehicle surface thus prevent-
ing it from moving.
Page 1 Copyright © 2007 Winfi eld Consumer Products