Denon AVR-891 Owner's Manual page 64

Setting items
GUI Format : Set the video signal format to be output for the TV you are using.
(Continued) • NTSC : Select NTSC output.
• PAL : Select PAL output.
"Format" can also be set by the following
procedure. However, the menu screen is not
displayed.
1. Press and hold the main unit's
least 3 seconds.
"Video Format" appears on the display.
o p
2. Press
3. Press the main unit's
to complete the setting.
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Text : Display the details of operation when switching surround mode,
input mode, etc.
• ON : Turn display on.
• OFF : Turn display off.
Master Volume : Display the master volume during adjustment.
• Bottom : Display at the bottom.
• Top : Display at the top.
• OFF : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to "Top".
USB : Set the USB screen display time when the input source is "USB/
iPod".
• Always : Show display continuously.
• 30sec : Show display for 30 seconds after operation.
• 10sec : Show display for 10 seconds after operation.
• OFF : Turn display off.
iPod : Set the iPod screen display time when the input source is "DOCK"
or "USB/iPod".
• Always : Show display continuously.
• 30sec : Show display for 30 seconds after operation.
• 10sec : Show display for 10 seconds after operation.
• OFF : Turn display off.
TUNER : Set the tuner screen display time when the input source is
"TUNER".
• Always : Show display continuously.
• 30sec : Show display for 30 seconds after operation.
• 10sec : Show display for 10 seconds after operation.
• OFF : Turn display off.
Remote control operation
buttons
Setting details
p i
and for at
and set the video signal format.
ENTER MENU RETURN
, or
Move the cursor
(Up/Down/Left/Right)
Setting items
Remote Preset Codes See "Registering preset codes" (vpage 63).
Search a preset code to
register in the remote
control unit.
Quick Select Name • Up to 16 characters can be input.
Change the "Quick Select" • For character input, see page 43.
display title to one you
prefer.
• Up to 10 characters can be input.
Zone Rename
Change the display title of • For character input, see page 43.
each zone to one you prefer.
Remote ID Setup 1 / 2 / 3 / 4
Used when receiving
NOTE
maintenance from a DENON
Only use this function if so instructed by a DENON serviceperson or
service engineer or custom
installer. installer.
Dimmer Bright : Normal display brightness.
Adjust the display Dim : Reduced display brightness.
brightness of this unit. Dark : Very low display brightness.
OFF : Turns the display off.
Buttons on the main unit can be used for
operations.
Each time
changed as shown below.
Bright
OFF
Setup Lock ON : Turn protection on.
Protect settings from OFF : Turn protection off.
inadvertent change.
When canceling the setting, set "Setup Lock" to "OFF".
NOTE
When "Setup Lock" is set to "ON", the settings listed below can no
longer be changed. Also, "SETUP LOCKED!" is displayed if you attempt
to operate related settings.
· Menu operations
· RESTORER
· Dynamic Volume™
Confirm the setting
Manual Setup
Setting details
DIMMER
is pressed, the setting is
Dim
Dark
· Channel Level
· MultEQ ®
· Dynamic EQ ®
Return to previous menu
ENGLISH
61