Denon AVR-891 Owner's Manual page 38

5
Set up "Channel Select"
Use to select "Channel Select",
ui
ENTER
and then press .
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ
STEP1 Preparation [1/6]
Connect the speakers
and place them accord-
ing to the recommenda-
tions in the manual.
Set the following
items if necessary.
Amp Assign
Channel Select
Auto Setup Start
ENTER Enter RETURN Cancel
Skip unused ch's measurement for timesaving
6
Use to select a channel.
ui
Front Select for setting the front speakers
to be used. In this case, go to step
7.
• "Front" can be set when "Amp
Assign" is set to "Front B".
Subwoofer Select for no subwoofers to be
used. In this case, go to step 8.
Select for no surround
Surround
speakers to be used. In this case,
Back
go to step 9.
• "Surround Back" can be set when
"Amp Assign" is set to "Normal".
7
GWhen "Front" is selected in step 6H
Press o p to select a front speaker.
A Select this to use front speaker A
B Select this to use front speaker B.
A+B Select this to use front speakers A and B
simultaneously.
Remote control operation
buttons
Set up speakers
8
GWhen "Subwoofer" is selected in
step 6H
Use o p to select the item.
Measure Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
9
GWhen "Surround Back" is selected
in step 6H
Use to select the item.
o p
Measure Set for measuring two surround back
(2spkrs) speakers.
Measure Set for measuring a surround back
(1spkr) speaker.
Set for no measuring of a surround
Skip
back speaker.
10
RETURN
Press .
Proceed to page 8 STEP 1 Preparation
step 5.
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
back volume. In event of a change, perform Audyssey
Auto Setup again.
Move the cursor
(Up/Down/Left/Right)
Confirm the setting
ENGLISH
35
Return to previous menu