Page 1
Convection Heater with remote control Model: R-082 INSTRUCTION MANUAL 220-240V~ 50Hz, 2000W This product is only suitable for well insulated spaces or occasional use. PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE USING THE APPLIANCE.
TECHNICAL DATA Model R-082 RATED AC220- VOLTAGE 240V/50Hz POWER 2000W GENERAL DIRECTIONS 1. Remove the packaging and make sure that the appliance is intact. If in doubt, do not use it and contact our Technical Assistance Centre. Packaging materials (plastic bags, polystyrene, staples etc.) must be kept out of the reach of children as they could be hazardous.
Page 3
Keep the suction grille clean. Do not use the appliance immediately below a fixed power outlet. WARNING In order to avoid overheating, do not cover the heater. CAUTION Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
PRODUCT PARTS Display Handle Control panel Main switch Air outlet Air inlet Feet OPERATION PANEL Power indication Fan indication Anti-frost indication Fan button Increase temperature button Decrease temperature button Timer button Set temperature indication Timer function indication Child lock function indication Actual temperature indication Power on/off button Child lock button...
Page 5
Switching on and off 1. The convector has two on/off switches. To switch the convector on, place the safety on/off switch on the left-hand side of the appliance into position I”. There is a separate switch for the heat setting. Press the on/off switch on the control panel of the appliance or on the remote control handset.
Children safety lock Press the button about 3 seconds on the operating panel of the appliance or the button on the remote control handset, the appliance will be run children safety lock function, the display panel are not illuminated and all function button will be locked. If you want to quit this function, press the button about 3 seconds again, the display panel are illuminated again and all function button will be unlocked.
Page 7
Information requirements for electric local space heaters Model R-082 Identifier(s) Item Symbol Value Unit Item Unit Heat output Type of heat input, for electric storage local space heaters only (select one) Nominal heat manual heat charge control, with [no] output...
Need help?
Do you have a question about the R-082 and is the answer not in the manual?
Questions and answers