Subscribe to Our Youtube Channel
Related Manuals for Rohnson R-031
Summary of Contents for Rohnson R-031
- Page 1 GLASS CONVECTION HEATER WITH Wi-Fi INSTRUCTION MANUAL Model No.: R-031 This product is only suitable for well insulated spaces or occasional use.
- Page 2 To get the most out of your new heater, please read through these instructions and the attached safety regulations before use. Please also save the instruction manual in case you need to remind yourself of the heater’s functions at a later date. Technical Specification Details R-031 Voltage 220-240V~ Frequency 50-60Hz Power...
- Page 3 external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. For your own safety 1. Read all instruction before using the heater. 2. Only connect the heater to a single-phase socket with a mains voltage as specified on the rating plate.
- Page 4 or fire or damage to the heater. 17. If the heater has been dropped or damaged it should not be used until it has been inspected by a qualified service center. 18. Close supervision is necessary when the heater is being used by or near children, persons suffering from any physical impairment or pets.
- Page 5 31. Do not leave the heater switched on when leaving your home or going to sleep. 32. Children should be supervised to ensure that they do not play with the appliance. 33. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge if they have been given supervision or instruction concerning use of the...
-
Page 6: Description Of The Symbols
Be very vigilant and avoid touching the hot parts. SPECIFICATION GH-1901-20-W Model: / R-031 Standard: IEEE 802.11 b/g/n Antenna Type: PCB Antenna Frequency WIFI: 2.400~2.4835GHz Maximum Transmitted Power: 18dBm Max Dimension: 16±0.35 mm (W)×24±0.35 mm (L) ×2.9±0.15 mm (H). -
Page 7: Simplified Eu Declaration Of Conformity
SIMPLIFIED EU DECLARATION OF CONFORMITY Hereby, Zhongshan SEEMAX Electrical Appliance Co., Ltd, declares that the radio equipment type of R-031 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.vassilias.gr... - Page 8 Image 1 2. Place the unit upright and check if the feet is fixed properly before use (Image 2) Image 2...
- Page 9 WALL MOUNTED USE Instruction for fixing the heater on wall: Image 3 - Take out 1# bracket (2pcs)/2# bracket(1pc)/ST4*14(4pcs) screws of the accessories bag. - Install 1# bracket at the back of the appliance by fixing the 4 screws (see picture). - Remove the middle one screw at the bottom of appliance and install 2# bracket here by fixing this one screw.
- Page 10 Image 4 - Installing range for 1# bracket:630mm - Use 6# pressing drill to drill out 1# bracket mounting holes on the wall, fit the holes with colloidal particles within the accessories bag, then fixing screws ST4*36 on the wall. （Note: Screw should appear 3-5mm）...
- Page 11 - Remove the appliance, use 6# pressing drill to drill out mounting holes on the wall, fit the holes with colloidal particles. - Hang the appliance on the wall, fixing 2# bracket with screws ST4*36. - Wall-mounted installation finished. LED display Tempered Touch button Glass...
- Page 12 Remote control Image 6 Please use 1 commercially available CR2025 button battery (battery is included). ① Pull out the battery box by pressing inside the groove of the battery box on the back of the remote control with your fingernail. Release CR2025 ②...
-
Page 13: Operation
OPERATION Place the heater on a stable and horizontally even ground. Plug in power supply, press ON/OFF button (at the bottom of right housing) to connect power. Press it again to disconnect power. LED display Program setting On/Standby switch Mode switch: Power setting/WIFI P1, P2, P3, P4, P5, UP Window open... - Page 14 Symbol Meaning Working at Full power 2000W Working at 1000W Anti-frost function Window open detection function WiFi connection d1,d2,d3,d4,d5,d6,d7 Mon. Tue. Wed. Thur. Fri. Sat. Sun. P1,P2,P3,P4,P5 Factory default program Customized program setting Touch once to switch on the appliance. Touch again to switch it off.
- Page 15 Touch once to confirm setting. After setting finish, touch once in standby mode to check if the current day and time setting is correct. Screen will automatically show “Day” – “Hour” – “Minutes” in turns within1 second each, then switch back to temperature display. For exampe, when your current day setting is Wed.
- Page 16 4. Mode Switch When appliance is switch on, touch to select program mode among PI, P2, P3, P4, P5, UP in cycle. - P1, P2, P3, P4, P5 are factory default program and cannot be changed - UP is customized program for end-user to set working period and mode upon their habit.
- Page 17 5. Timer Setting In P1 working mode, touch twice quickly to activate timer setting. Icon flashes on the screen, then touch to set timer reverse among 0 to 24 hours. It will save automatically in 5 seconds after setting. Icon stop flashing and appliance starts count down to turn off.
- Page 18 - In comfort mode working time, you may touch to switch power setting among (2000W) and (100W). - In spite of the set period, appliance will display and keep the ℃ room temperature at anti-frost mode at 5 3) Touch button to confirm every setting, when d1 setting is finish, it will automatically turn to d2.
- Page 19 to cancel the setting, icon disappear. In window open detection mode, when appliance is heating, but room temperature is found to drop 5°C in 10 minutes, appliance will consider the window may open and start detection. In the next 30 minutes, if room temperature hasn’t raised, appliance will consider the window is open and stop heating.
-
Page 20: Maintenance
DETAILS FOR Wi-Fi CONNECTIVITY Please scan QR code to download Rohnson APP for Android as below. APP Store for IOS mobile device... - Page 21 Connection by WIFI 1.Use your phone to scan the QR code above or search “Rohnson” App in Play store or App store. Download and install the Rohnson App. 2.Select Register. Then, select your country, enter email and tap “Continue” to get a message containing verification on code.
- Page 23 The product will be added successfully In case you see this message, please check the three possible reasons and retry...
- Page 24 Now, the unit is off. Press the on/off switch to turn the unit on. Then, the unit is on. You can adjust your desired temperature from 5-40°C.
- Page 25 Select Mode to set your desired heating mode. P1, P2, P3, P4, P5 are factory default program and cannot be changed. - UP is customized program to set working period and mode upon your needs. If you want to change the UP program, you have to do it manually on the device.
- Page 26 1000W 2000W Select Gear to choose between 1000W and 2000W.
- Page 27 You can select the desired timer to turn the unit off (1-24h)
- Page 28 Select Settings to turn on/off the child lock and window open detection function.
- Page 29 Select this button for more options on your device. You can change your product’s name, check device info or share your device with other people. Choose device sharing, add sharing, share with the Account Rohnson or other options. You can share the product with maximum 20 people.
- Page 31 IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection center or to a dealer providing this service.
- Page 32 Information requirements for electric local space heaters Model number: R-031 Item Symbol Value Unit Item Symbol Value Unit Heat Output Type of heat input, for electric storage local space heaters only (select one) Nominal Manual heat charge heat control, with integrated...
- Page 33 day timer electronic room temperature control plus week timer Other control options (multiple selections possible) room temperature control, with presence detection room temperature control, with open window detection with distance control option with adaptive start control with working time limitation with black bulb sensor...
Need help?
Do you have a question about the R-031 and is the answer not in the manual?
Questions and answers