Page 1
Convection Heater with remote control Model: R-019 INSTRUCTION MANUAL...
Page 2
TECHNICAL DATA Model R-019 R-019 RATED VOLTAGE AC220-240V/50/60Hz AC220-240V/50/60Hz POWER 2300W 2300W GENERAL DIRECTIONS Remove the packaging and make sure that the appliance is intact. If in doubt, do not use it and contact our Technical Assistance Centre. Packaging materials (plastic bags, polystyrene, staples etc.) must be kept out of the reach of children as they could be hazardous.
Page 3
Keep the suction grille clean. Do not use the appliance immediately below a fixed power outlet. WARNING In order to avoid overheating, do not cover the heater. CAUTION Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
Page 4
Operation panel function introduction 1 Selected heating level display 14 Button for selecting unit of measurement 2 "Fan" symbol 15 Button for selecting the heat setting 3 "Frost protection" symbol 4 Selected unit of measurement display 5 Fan button 6 Increase temperature 7 Reduce temperature 8 Timer button 9 Running time display...
Page 5
On/Off button 5. Button for selecting the heat setting Fan button 6. Button for selecting unit of measurement Increase temperature 7. Reduce temperature Timer button Key function introduction POWER function Insert the plug in a suitable power socket. After the power is turned on, the computer board emits a “click” sound, the screen displays the current room temperature and the set temperature, and other displays are not displayed.
Page 6
FAN: Press the fan to open the key, you can open the fan or turn off the fan (on the screen fan icon is light fan, Figure off the wind organ); In anti-frost mode: In the standby mode, the room temperature is lower than 5°C, and automatically enters the high-grade (2300W) heating mode.
Need help?
Do you have a question about the R-019 and is the answer not in the manual?
Questions and answers