Playback - Denon AVR-2112CI Owner's Manual

Playback

1
ZONE SELECT
Press to switch the
zone mode to K (ZONE2).
2
Press AMP to set the remote
control unit to AMP-operation
mode.
3
Press ZONE/DEVICE Z to turn on
the ZONE2 power.
The indicator on the display lights.
• Also press input source select button when
in standby mode, the power turns on.
ZONE/DEVICE X
• When is pressed, ZONE2
turns off.
• Power in ZONE2 can be turned on or off by
ZONE2 ON/OFF
pressing on the main unit.
4
Press the input source select
button.
The audio signal of the selected source
is output to ZONE2.
• To perform an operation with the main unit, press
many times.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select
ZONE/DEVICE X
step 1 then press .
BD
Adjusting the volume
(for "q ZONE2 playback by speaker output")
M df
Use to adjust the volume.
GAdjustable rangeH – – –
Input source
(When the "Volume Display" (vpage 95) setting is "Relative")
select buttons
GAdjustable rangeH
(When the "Volume Display" (vpage 95) setting is "Absolute")
• At time of purchase, "Volume Limit"
"–10dB (71)".
MASTER VOLUME
• Turn
unit to adjust the sound volume.
• For "w ZONE2 playback by audio output", adjust the volume on the
connected amplifier.
ZONE2 SELECT
Turning off the sound temporarily
N
Press .
The sound is reduced to the level set at "Mute Level" (vpage 94)
in the menu.
• To cancel, either adjust the volume or press
J
(MAIN ZONE) in
• The setting is canceled when the zone's power is turned off.
–80dB – –40dB – 18dB
0 – 41 – 99
(vpage 94) is set to
ZONE2 SELECT
after pressing on the main
N
again.
vSee overleaf
71