Connecting An External Control Device - Denon AVR-2112CI Owner's Manual

Connecting an external control device

REMOTE CONTROL jacks
If this unit is installed in a location that is out of range of the signal
from the remote control unit, you can still operate the unit and the
devices connected to it by using a commercially available IR receiver.
You can also use it to remotely control ZONE2 (another room).
Infrared
Infrared
retransmitter
sensor
Device equipped with a
REMOTE CONTROL IN jack
Output
Input
AUX
OUT
RS-232C connector
When you connect an external control device, you can control this unit
with the external control device.
External serial controller
Perform the operation below beforehand.
q Turn on the power of this unit.
w Turn off the power of this unit from the external controller.
e Check that the unit is in the standby mode.
13