Guiding Signals - Dell M209X User Manual

Guiding Signals

Projector Status
Standby mode Projector in Standby mode. Ready to power on.
Warming up Projector takes some time to warm up and power
on.
mode
Lamp on Projector in Normal mode, ready to display an
image.
Note: The OSD menu is not accessed.
Cooling mode Projector is cooling to shutdown.
Power Saving Power Saving mode has been activated. The
projector will automatically enter standby mode, if
mode
an input signal is not detected in two hours.
Cooling before The projector takes 60 seconds to cool down before
entering Power Saving mode.
Power Saving
mode.
Projector over- Air vents might be blocked or ambient temperature
may be above 35℃. The projector automatically
heated
shuts down. Ensure that the air vents are not
blocked and that the ambient temperature is within
operational range. If the problem persists, contact
Dell.
Lamp over- The lamp is over heated. The air vents may be
blocked. The projector automatically shuts down.
heated
Turn the display on again after the projector cools
down. If problem persists, contact Dell.
Lamp driver The lamp driver is over heated. The air vents may
be blocked. The projector automatically shuts
over-heated
down. Turn the display on again after the projector
cools down. If the problem persists, contact Dell.
Fan breakdown One of the fans has failed. The projector
automatically shuts down. If the problem persists,
contact Dell.
Lamp driver The lamp driver has failed. The projector
automatically shuts down. Unplug the power cord
breakdown
after three minutes then turn the display on again. If
this problem persists, contact Dell.
Color Wheel Color wheel cannot start. The projector has failed
and the projector automatically shuts down.
breakdown
Unplug the power cord after three minutes and
turn on the projector.. If this problem persists,
contact Dell.
Lamp failure Lamp is defective. Replace the lamp.
Fault - DC Power supply has been interrupted. The projector
automatically shuts down. Unplug the power cord
supply (+12V)
after three minutes and then turn on the projector. If
this problem persists, contact Dell.
Fault - DC Power supply has been interrupted. The projector
automatically shuts down. Unplug the power cord
supplies
after three minutes and then turn on the projector. If
(secondary)
this problem persists, contact Dell.
*Others: control buttons on the control panel exept Power and Menu
34 Troubleshooting Your Projector
Description
Control Buttons
Power Menu Others
BLUE
OFF OFF
Flashing
BLUE BLUE BLUE
BLUE BLUE OFF
BLUE OFF OFF
AMBER
OFF OFF
Flashing
AMBER OFF OFF
OFF OFF OFF
BLUE OFF OFF
AMBER OFF OFF
OFF OFF OFF
AMBER
OFF OFF
Flashing
BLUE OFF OFF
OFF OFF OFF
AMBER
OFF OFF
Flashing
AMBER
OFF OFF
Flashing
Indicator
TEMP LAMP
(Amber) (Amber)
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
AMBER OFF
AMBER OFF
AMBER OFF
AMBER
OFF
Flashing
AMBER
OFF
Flashing
AMBER AMBER
Flashing Flashing
OFF AMBER
AMBER AMBER
AMBER OFF