D-Link DHP-1320 User Manual page 40

Section 3 - Configuration
Choose L2TP (Layer 2 Tunneling Protocol) if your ISP uses a L2TP connection. Your ISP will provide you with a username and password. This option
is typically used for DSL services.
Address Mode:
Select Static if your ISP assigned you the IP address, subnet
mask, gateway, and DNS server addresses. In most cases, select
Dynamic.
L2TP IP Address:
Enter the L2TP IP address supplied by your ISP (Static only).
L2TP Subnet
Enter the Subnet Mask supplied by your ISP (Static only).
Mask:
L2TP Gateway IP
Enter the Gateway IP Address provided by your ISP.
Address:
L2TP Server IP
Enter the Server IP provided by your ISP (optional).
Address:
Username:
Enter your L2TP username.
Password:
Enter your L2TP password and then retype the password in
the next box.
Reconnect
Use the radio buttons to specify the reconnect mode. The user can specify a custom schedule or specify the On Demand, or Manual
Mode:
option.
Maximum Idle Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable
Time:
Auto-reconnect.
Primary DNS
Enter the Primary DNS server IP address assigned by your ISP. These address is usually obtained automatically from your ISP. Enter
Server:
the value 0.0.0.0 if you did not specifically receive these from your ISP.
D-Link DHP-1320 User Manual
Manual Internet Connection Setup
L2TP
35