Table of Contents
Advertisement
Section - Security
Configure WPA-Enterprise (RADIUS) In AP Mode
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the access point (192.168.0.50).
Click on Setup and then click Wireless Settings on the left
side.
2. Next to Security Mode, select WPA-Enterprise.
3. Next to WPA Mode, select Auto WPA or WPA2, WPA2 Only,
or WPA Only. Use Auto if you have wireless clients using both
WPA and WPA2.
4. Next to Cipher Type, select TKIP, AES or TKIP and AES
5. Next to Group Key Update Interval, enter the amount of time
before the group key used for broadcast and multicast data is
changed (3600 is default).
6. Next to Authentication Timeout, enter the amount of time before
a client is required to re-authenticate (60 minutes is default).
7. Next to RADIUS Server IP Address enter the IP Address of your
RADIUS server.
8. Next to RADIUS Server Port, enter the port you are using with
D-Link DAP-1555 User Manual
Advertisement
Table of Contents
