Networking Basics; Check Your Ip Address - D-Link DCS-5610 User Manual

Ptz poe internet camera

Hide thumbs Also See for DCS-5610:

Table of Contents

Appendix B - Networking Basics

Networking Basics

After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a

DHCP server (i.e. wireless router) automatically. To verify your IP address, please follow the steps below.

Click on Start > Run. In the run box type cmd and click OK.

At the prompt, type ipconfig and press Enter.

This will display the IP address, subnet mask, and

the default gateway of your adapter.

If the address is 0.0.0.0, check your adapter

installation, security settings, and the settings

on your access point. Some firewall software

programs may block a DHCP request on newly

installed adapters.

If you are connecting to a wireless network at a hotspot (e.g. hotel, coffee shop, airport), please contact an employee

or administrator to verify their wireless network settings.

D-Link DCS-5610 User Manual

Table of Contents