Assembly Preparation; Important Assembly Instructions - Hoppecke grid XtreneStack Assembly Manual

➢ Warning signs in accordance with EN 62485-3 must be affixed
in the battery room
No ignition sources in the vicinity of the cell openings
➢
➢ The specified operating temperature is between 20°C - 25°C
Lower temperatures lead to a reduced available capacity and
care must be taken to ensure that the maximum limit
temperatures of the batteries are not exceeded
The environment must be clean and dry
➢
➢ The access door must be lockable and fire-retardant

5 Assembly preparation

➢ Check the goods for paint damage or defective components.
➢ Check the goods for completeness.
If components
➢
supplier/seller.
➢ Ensure that the floor is stable and level for installation to ensure
a vertical, perpendicular and stable installation.
➢ Check the walls/floors to ensure that the wall or floor bracket can
be securely and stably attached.

6 Important assembly instructions

Once the stacking device has been successfully installed, ALL screws, nuts
and front openings must be covered with caps.
When wiring the battery system, insulated cables and connectors in
accordance with EN 62485-2 must be used.
are defective
www.hoppecke.com
or missing, contact the
5/20