Advertisement
Advertisement
Table of Contents
Related Manuals for BRIO CLPOUROSC420
Summary of Contents for BRIO CLPOUROSC420
- Page 1 USER’S MANUAL Point of Use Water Cooler MODEL NO. CLPOUROSC420 Thank you for purchasing a Brio water cooler. Please read this user’s manual thoroughly for using the water coolers safely and appropriately. HOT, ROOM & COLD POINT OF USE ENERGY STAR...
-
Page 2: Safety Precautions
SAFETY PRECAUTIONS • Plug in the dispenser in the way described in this manual. • In accordance with these instructions, the dispenser must be properly located and installed before use • Use only water. Do not use co ee, tea or other beverages. •... -
Page 3: Connecting The System
INSTALL TEE FITTING Turn o the cold water supply to the sink. Turn on the kitchen faucet to release pressure and allow water to drain from the line. Disconnect the cold water line from the threaded stem on the bottom of the kitchen faucet. - Page 4 INSTALL RO DRAIN CONNECTOR WARNING CAUTION Be sure that all electrical appliances and Please wear safety outlets are turned off at the circuit breaker glasses to protect before working in the cabinet area. eyes when drilling. Note: To avoid possible drainage noise, mount drain line as low as possible on the vertical tailpiece, or on horizontal tailpiece.
- Page 5 Working with your home's plumbing system can be unsafe and difficult to do correctly without the proper training. Also, your system will need to be connected to piping in a relatively cramped space (behind and underneath your sink) and it can be especially difficult to adequately tighten plumbing connections in that small space without the know-how and specific tools.
- Page 6 Remove the Air inside the Hot Water Tank After installing the lter, remove the air inside the Hot Water Tank by pressing and holding the Hot Water Lever as shown in the following gure until water starts to come out of the water outlet.
- Page 7 Hot, Cold, & Room Faucets Hot | Room | Cold Press the button on the right for Cold Water, middle for room temperature water, & left button for hot water. Place a cup directly below a faucet and depress the correct lever, but be careful using the hot water. Even when a bottle is empty, Cold Water is available, for a small volume, but hot water is not available when the bottle is empty.
- Page 8 Cleaning the POU cooler 1. Disconnect power cord from outlet. 2. Remove top of cooler and inner oat assemby to expose the cold tank below. 3. Drain reservoir through the cold water (light blue) faucet and the hot water (red if you have a hot and cold water cooler) faucet into a bucket and throw that away.
-
Page 9: Troubleshooting
TROUBLESHOOTING Please check the following items prior to asking for repair Troubles Things to check Troubleshooting Water shut-off valves. Open all water shut-off valves. Water does not come out (Cold Water & Hot Water) Is the air inside the Tank removed Press and hold the lever until the water completely? comes out through Hot Water Faucet. -
Page 10: Specifications
About 1.1ℓ (Stainless Steel Tank) * For the improvement of product Brio reserves the right to change specifications without notice. * You must confirm the correct voltage(V) and frequency(Hz) and then plug to the outlet. Check the proper voltage in the back of dispenser.
Need help?
Do you have a question about the CLPOUROSC420 and is the answer not in the manual?
Questions and answers