Table of Contents
Advertisement
A
t
t
a
c
h
i
n
g
t
h
e
S
l
o
A
t
t
a
c
h
i
n
g
t
h
e
S
l
o
The AstroMaster mount comes with two slow motion control cables that allow you to make fine pointing
adjustments to the telescope in both R.A. and Declination. To install the cables:
1. Locate the two cables with knobs on them (both are identical is size and length) and make sure the screw on
each cable end does not protrude through the opening.
2. Slide the cable onto the R.A. shaft as far as it will go. There are two R.A. shafts, one on either side of the
mount. It makes no difference which shaft you use since both work the same. Use whichever one you find
more convenient.
3. Tighten the screw on the R.A. cable to hold it securely in place.
4. The DEC slow motion cable attaches in the same manner as the R.A. cable. The shaft that the DEC slow
motion knob fits over is toward the top of the mount, just below the telescope mounting platform.
Figure 2-15
R.A. Shaft on bottom and Dec. Shaft on top
A
t
t
a
c
h
i
n
g
t
h
e
T
e
A
t
t
a
c
h
i
n
g
t
h
e
T
e
The telescope optical tube attaches to the mount via a dovetail slide bar mounting bracket at the top of the mount
(Figure 2-16). For the 130 EQ Newtonian, the mounting bar is the bracket which is attached to the tube rings. For
the 90 EQ refractor the mounting bar is attached along the bottom of the telescope tube. Before you attach the
optical tube, make sure that the declination and right ascension locking knobs are tight (Figure 2-17). Then,
make sure that the latitude adjustment screws (Figures 1-1 & 1-2) are tight. This will ensure that the mount
does not move suddenly while attaching the telescope optical tube. Also, remove the objective lens cap (refractor) or
the front opening cap (Newtonian). To mount the telescope tube:
1. Remove the protective paper covering the optical tube. You will have to remove the tube rings on the 114 EQ
Newtonian before removing the paper.
2. Loosen the mounting knob and the mounting safety screw on the side of the dovetail mounting platform so they
do not protrude into the mounting platform – see Figure 2-18.
3. Slide the dovetail mounting bar into the recess on the top of the mounting platform (figure 2-17).
4. Tighten the mounting knob on the dovetail mounting platform to hold the telescope in place.
5. Hand tighten the mounting platform safety screw until the tip touches the side of the mounting bracket.
NOTE:
Never loosen any of the knobs on the telescope tube or mount other than the R.A. and DEC. knobs.
Hint:
For maximum rigidity of the telescope and mount, make sure the knobs/screws holding the tripod legs to
the tripod head are tight.
w
M
o
t
i
o
n
C
a
b
l
e
w
M
o
t
i
o
n
C
a
b
l
e
l
e
s
c
o
p
e
T
u
b
e
t
o
l
e
s
c
o
p
e
T
u
b
e
t
o
s
s
R.A. & Dec. Cables with knobs attached
t
h
e
M
o
u
n
t
t
h
e
M
o
u
n
t
8
Figure 2-16
Hide quick links:
Advertisement
Table of Contents
