Page 13
Product Manual : Ver 1.00 FES-160 Amenity Dome M TC...
Page 14
Thank you for purchasing a Snow Peak product. This product is a tent for camping. For safety, read the following instruction manual before use. Please keep it safe for future reference. Finally, if you find anything that you do not understand in the description or any problems with the product, please stop use immediately and contact the retailer or Snow Peak Customer Service.
Page 15
●Before using the product, check each part for abnormalities. If there are abnormalities, take the product to the dealer or Snow Peak Customer Service for inspection or repair. ●Pay close attention to the weather. If there are strong winds or extreme weather is in the forecast, pack up camp immediately and evacuate to a safe place.
Page 16
Name of the Parts * To use the tent with the vestibule main door flipped up, you will need poles, ropes, and pegs. [Fly sheet] Velcro tape Guy line ring Vestibule sleeve Velcro tape Vestibule main door panel Side panel Tape pocket Vestibule side door Vestibule frame...
Page 17
Before Using This Product for the First Time While utmost care is taken to ensure quality, be sure to test it first and check all the accessories and setup procedure before actual use. If you find any defects, contact your local dealership or Snow Peak User Service.
Page 18
Setup Procedure: Make sure to set up the tent with two or more people in order to ensure safety. Spread the inner tent on a flat surface. * The tent has two entrances. The side with the building tape is the vestibule, which is the main entrance.
Page 19
Insert pins into the other cross frame in the same manner and set up Figure G the tent. [Figure G] * Keeping the door panels and side panel halfway open allows air to enter the room, making the setup easier. Insert pins into both ends of the side frame.
Page 20
Check the direction of the vestibule and back room, and put the fly sheet over the frames. [Figure K] * Wind the velcro tapes on the inside of the fly sheet onto the frames to prevent shifting and keep it in place.
Page 21
Pull the ends of the vestibule and back room, and drive pegs through the rubber loops. [Figure M] * Do not use excessive force to pull. Pulling too hard causes excessive force to be applied on the fasteners, which may cause breakage. After pegging down all corners, remove the buckle of the vestibule building tape, bundle the tape, and store it in the tape pocket.
Page 22
Storing the Product in the Case Fold the main unit and fly sheet to fit the length of the carrying bag and put them in the bag. Place the frames and pegs in their dedicated cases, and then store them in the carrying bag. Storing them exposed in the carrying bag may damage the fabric of the main unit and/or the carrying bag.
Page 23
Peak Customer Service. If there are apparent defects in the product's manufacturing, the defective product will be repaired or exchanged free of charge. In other cases, Snow Peak will repair the product for an appropriate fee. The decision to repair or replace the product will be at our discretion. Snow Peak will not repair the product for any damage that occurred due to the following 1.
Page 24
●Transportation and repair costs are determined as follows: 1. Within warranty: The transportation cost (both ways) and repair cost will be covered by Snow Peak. 2. Outside warranty: The transportation cost (both ways) and repair cost will be covered by the customer.
Need help?
Do you have a question about the Amenity Dome M TC and is the answer not in the manual?
Questions and answers