Fitting The Embroidery Frame To The Embroidery Unit - Brother PC-850D Operation Manual

Fitting the embroidery frame to the embroidery unit

1
1
6. Remove the embroidery sheet before starting to embroider.
1
1 Hole for removing
Be sure to wait until the embroidery unit has finished
initializing before fitting the embroidery frame. (Refer to
page 109.)
1. Raise the presser foot to its highest position. Then pass the
embroidery frame under the presser foot with the mounting
bracket on the left side and the fabric right side up.
2. Align the two pins on the embroidery unit frame holder with
the mounting bracket on the frame, and then press the
frame into the embroidery unit frame holder until a click is
2
heard.
1 Embroidery arm frame holder
2 Pins
* Be sure to insert both pins. If only the forward or the back
pin is inserted, the pattern may not turn out correctly.
Removing the embroidery frame
While pushing the lever of the embroidery frame holder to the
left, lift the embroidery frame up to remove it.
1 Lever
119