Dual Access - Brother MFC-8440 User Manual

Dual Access

You can dial a number, and begin scanning the fax into memory—
even when the MFC is receiving, sending or printing a fax from
memory. The LCD shows the new job number.
If you get a Out Of Memory message while scanning the first
page of a fax, press
Out Of Memory message while scanning a subsequent page,
you can press
Stop/Exit
1
If it is not illuminated in green, press
original face up in the ADF, or face down on the scanner glass.
2
Enter the fax number.
3
Start
Press
The MFC starts scanning the first page and the LCD shows the
job number (#XXX) of the fax. You can repeat Steps 1 to 3 for
the next fax.
—OR—
If you are using the scanner glass, go to Step 5.
4
To send a single page,
2
press (or press
The MFC starts sending the
original.
—OR—
To send more than one page,
1
press and go to Step 5.
5
Place the next page on the
scanner glass. Press
The MFC starts scanning, and
then returns to Step 4. (Repeat
Steps 4 and 5 for each additional
page). To send the next fax, go to Step 1.
6 - 9 SETUP SEND
Stop/Exit
Start
to send the pages scanned so far, or press
to cancel the operation.
to send the fax.
Start
again).
Set
.
to cancel scanning. If you get a
Fax
(
Flatbed Fax:
Next Page?
▲
1.Yes
▼
2.No(Send)
▲▼
Select
Flatbed Fax:
Set Next Page
Then Press Set
). Place the
& Set