Brother DCP-7065DN Basic User's Manual page 60

Error Message
Out of Memory
Print Unable XX
Replace Drum
Replace Toner
Size Error DX
Toner Ended
Toner Low
46
Cause
The machine's memory is full.
The machine has a mechanical
problem.
It is time to replace the drum unit. Replace the drum unit.
The drum unit counter was not
reset when a new drum was
installed.
The machine will stop printing
until you replace the toner
cartridge.
The paper in the tray is not a
suitable size for automatic duplex
printing.
It is time to replace the toner
cartridge.
You will need to replace the toner
cartridge soon.
Action
Do one of the following:
 Press Start to copy the scanned pages.
(Copy operation in progress)
 Press Stop/Exit and wait until the other
operations in progress finish, and then
try again.
 Reduce print resolution. (See the Basic
tab in the Software User's Guide.)
Do one of the following:
 Disconnect the machine from the AC
power outlet for several minutes, then
reconnect it.
 If the problem continues, call Brother
Customer Service.
(See Replacing the drum unit on page 40.)
Reset the drum unit counter.
(See Resetting the drum counter
on page 43.)
If you have set the Toner setting to Stop,
replace the toner cartridge with a new and
unused genuine Brother toner cartridge.
This will reset the Replace Toner mode.
(See Replacing the toner cartridge
on page 33.)
If you have set the Toner setting to
Continue, the machine will continue to
print data until the LCD shows Toner
Ended. For how to operate the machine in
Continue mode, see Toner Settings in
Chapter 1 of the Advanced User's Guide.
Load either Letter, Legal or Folio paper for
automatic duplex printing, and then press
Start. (See Print media on page 89.)
Replace the toner cartridge with a new one.
(See Replacing the toner cartridge
on page 33.)
Buy a new toner cartridge before you get a
Replace Toner message.