For Network Users - Brother DCP-395CN Software User's Manual

Remote Setup & PhotoCapture Center

For network users

a
Put a memory card or USB Flash memory drive into your machine.
b
Launch any FTP software or any web browser in which FTP is supported.
Your browser software accesses the memory card or USB Flash memory drive using the FTP protocol
and the network Host Name of the machine. In the address bar, enter ftp://XXX.XXX.XXX.XXX (where
XXX.XXX.XXX.XXX is the IP address of your Brother machine).
Your browser software appears and a list of file names on your memory card or USB Flash memory drive
is shown.
c
Click the name of the file you want to see.
Note
Using certain characters or symbols in a file name on the memory card or USB Flash memory drive may
cause a problem accessing the file. We recommend to only use combinations of the following characters
in a file name.
1234567890
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
! # $ % & ' ( ) - , @ ^ _ ' { } ˜
When you take out a memory card or USB Flash memory drive, do the following to prevent damage
to the memory card or USB Flash memory drive:
a
Close the browser.
b
Wait until the
Flash memory drive.
CAUTION
DO NOT take out the memory card or USB Flash memory drive while Photo Capture is blinking to avoid
damaging the card, USB Flash memory drive or the data stored on them.
If you take out the memory card or USB Flash memory drive while the Photo Capture key is flashing, you
must restart your Macintosh at once before putting the same memory card or USB Flash memory drive into
the machine. If you do not restart your Macintosh, the data on your media may be destroyed.
®
(Photo Capture) key stops blinking before taking out the memory card or USB
11
11
11
164