Motorola HT-1000 Service Manual page 54

Unit with
early Front Shield
Chassis
Assembly
32
Front Cover
Assembly
Front Cover/
Display Flex
MAEPF-22572-O
Figure 6 Rotating the Front Cover
TECHNICAL PUBLICATIONS DEPT.
6. Disconnect the front cover display flex from the connector on the
chassis.
NOTE:
Top Corner
Pry Here
a. Use the flex connector opening tool, large curved end
(Motorola part no. 6680334E08), or like instrument to help
raise the sliding portion of the connector approximately 1/8
of an inch from its seated position. A slight prying action will
achieve the best results for unlocking the connector.
b. Remove the flex from the chassis connector.
7. Remove the contoured O-ring/antenna bushing seal from the
chassis.
8. Disconnect the controls flex from the connector on the controller
board by following the procedure in step 6a and 6b.
Unit with
latest Front Shield
Chassis
Assembly
A special locking connector secures the flex to
the chassis (see Figure 7).
Flex Locked
in Connector
Top Corner
Pry Here
Figure 7 Disconnecting the Flex
Front Cover
Assembly
Front Cover/
Display Flex
MAEPF-27016-O
Flex Released
From Connector